İstaBreeze 2000W 48V Wind Turbine İ-2000

İstaBreeze 2000W 48V Wind Turbine İ-2000

iSTABreeze i-2000 48 Volt 2000 Watt Land type wind generator

Area of use   It is preferred wherever electricity is needed, in chalets and summer houses.

Provides charging current even at low wind speeds.

Wings with an aerodynamic structure have a strong and unbreakable structure.

Charge controller connection matters needing attention!!!

one.           Mount the charger close to the battery and in a place that is not hot.

2.          Mount the load resistor horizontally, away from the battery and control device.

3.          First connect the + terminals of the battery and the charger, then the – terminals, then connect the load resistor (resistance) connection to the load outputs and finally connect the 3 phase (ph) inputs coming from the turbine.

4.          Check that the terminal connection screws are tightened well.

5.          Check that the charge controller inverter and battery group are at the same voltage.

6.          To stop the turbine manually, place a switch between the wind turbine and the charge controller that will reduce it to a three-phase short circuit when necessary (you can use a 63 k automaton or a 3x25 on-off switch).

7.          Be sure to ground the body of the pole.

8.          The length of the pole may be around 6-12 meters.

9.          You can mount the pole tightly with ropes on 3 sides to prevent shaking in the wind.

10.      Do not drill any part of the device while the charger is connected to the system. If you are going to drill for installation, the device must be in the off position.

This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.