İstaBreeze İ-1000 WATT 24 V Wind Turbine + Hybrid Charge Controller

İstaBreeze İ-1000 WATT 24 V Wind Turbine + Hybrid Charge Controller

CHARGER CONTROLLER CONNECTION ISSUES TO BE CONSIDERED!!!

one.         INSTALL THE CHARGER IN A PLACE CLOSE TO THE BATTERY AND WHERE IT IS NOT HOT.

2.         INSTALL THE LOAD RESISTANCE HORIZONTALLY AWAY FROM THE BATTERY AND CONTROL DEVICE.

3.         FIRST CONNECT THE + TERMINALS OF THE BATTERY AND THE CHARGER, THEN THE – TERMINALS, THEN CONNECT THE LOAD RESISTANCE TO THE LOOD OUTPUTS, AND LAST CONNECT THE 3 PHASE COMING FROM THE TURBINE TO THE (PH) INPUTS.

4.         CHECK THAT THE TERMINAL CONNECTION SCREWS ARE TIGHTENED WELL.

5.         CHECK THAT THE CHARGER CONTROLLER, INVERTER AND BATTERY GROUP ARE THE SAME VOLTAGE.

6.         TO STOP THE TURBINE MANUALLY, PUT A SWITCH BETWEEN THE WIND TURBINE AND THE CHARGER CONTROLLER THAT WILL TURN IT TO A THREE PHASE SHORT CIRCUIT IF NECESSARY (63 K AUTOMAT OR 3X25 ON-OFF PAKO).

7.         MAKE SURE TO GROUND THE BODY OF THE POLE.

8.         THE LENGTH OF THE POST MAY BE AROUND 6-12 METERS.

9.         YOU CAN MOUNT THE POLE TIGHTLY WITH ROPE FROM 3 SIDES AGAINST SHAKING IN THE WIND.

10.     DO NOT DRILL ANY PART OF THE DEVICE WITH A DRILL WHILE THE CHARGER IS CONNECTED TO THE SYSTEM. IF YOU ARE GOING TO DRILL FOR INSTALLATION, THE DEVICE MUST BE IN OFF POSITION.

İSTA BREEZE İ-1000 W 24 V Wind Turbine + Hybrid Charge Controller

Original wind generator iSTA Breeze i-1000

Extremely robust wind generator of the latest generation. Composite rotor blades are very durable and robust and at the same time unusually light.

The body is equipped with cooling fins and is made of high-strength aluminum. The maintenance-free sliding contact (brush-free) guarantees a good current flow and therefore ensures that the cable is not twisted inside the pole.

Mounting on pole pipe with cable connection. Required mast pipe inner diameter: 37 mm nominal size! Other technical data are described in more detail in the description.

This product has been used successfully 1000 times worldwide! You can find the matching charge controllers and poles in our store! It can also be used with photovoltaic solar cells with our 24 volt charge controller.

Product Description:

IstaBreeze®'s wind/solar hybrid charger is intelligent control of wind turbine and solar cells that you control simultaneously.

The high-tech device can also be used as a monitoring system. It is used to charge and control your battery safely and efficiently with the combination of Wind Generator / Solar Module.

With its robust appearance, simple operation and integrated protection functions, this device has high efficiency and low load losses.

This version of the control unit will significantly increase the life and stability of the entire system, especially the batteries.

Special features and product information are listed below:

·          Use of solid state components. Increasing the lifespan of the controller.

·          Microprocessor controlled charging with integrated voltage and current limiting.

·          Electromagnetic brake control, the generator will automatically brake gradually when the battery is full, modern brake system in three steps to prevent the turbine from instantly clogging. It increases the life of the stator.

·          Protection against overcharge, deep discharge, short circuit, overload and false reverse polarity.

·          USB port with external display possibility.

This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.