IstaBreeze 500W 24V Wind Turbine - Air Speed

İstaBreeze 500 WATT 24 VOLT Wind Turbine - Air Speed

CHARGER CONTROLLER CONNECTION ISSUES TO BE CONSIDERED!!!

one.         INSTALL THE CHARGER IN A PLACE CLOSE TO THE BATTERY AND WHERE IT IS NOT HOT.

2.         INSTALL THE LOAD RESISTANCE HORIZONTALLY AWAY FROM THE BATTERY AND CONTROL DEVICE.

3.         FIRST CONNECT THE + TERMINALS OF THE BATTERY AND THE CHARGER, THEN THE – TERMINALS, THEN CONNECT THE LOAD RESISTANCE TO THE LOOD OUTPUTS, AND LAST CONNECT THE 3 PHASE COMING FROM THE TURBINE TO THE (PH) INPUTS.

4.         CHECK THAT THE TERMINAL CONNECTION SCREWS ARE TIGHTENED WELL.

5.         CHECK THAT THE CHARGER CONTROLLER, INVERTER AND BATTERY GROUP ARE THE SAME VOLTAGE.

6.         TO STOP THE TURBINE MANUALLY, PUT A SWITCH BETWEEN THE WIND TURBINE AND THE CHARGER CONTROLLER THAT WILL TURN IT TO A THREE PHASE SHORT CIRCUIT IF NECESSARY (63 K AUTOMAT OR 3X25 ON-OFF PAKO).

7.         MAKE SURE TO GROUND THE BODY OF THE POLE.

8.         THE LENGTH OF THE POST MAY BE AROUND 6-12 METERS.

9.         YOU CAN MOUNT THE POLE TIGHTLY WITH ROPE FROM 3 SIDES AGAINST SHAKING IN THE WIND.

10.     DO NOT DRILL ANY PART OF THE DEVICE WITH A DRILL WHILE THE CHARGER IS CONNECTED TO THE SYSTEM. IF YOU ARE GOING TO DRILL FOR INSTALLATION, THE DEVICE MUST BE IN OFF POSITION.

Air Speed 24V Wind Turbine İSTA-BREEZE

We are pleased to present the new wind generator IstaBreeze® AIR Speed, which is universally applicable for light, medium and strong wind. The newly developed IstaBreeze® AIR Speed provides reliable energy automatically and unattended even in harsh conditions, with our smart hybrid charge controller developed in Germany, for long-term professional use. It is a wind generator for The generous sizing of the generator components and the newly developed aluminum body and heat dissipation with the aluminum body ensure a low thermal load, ensuring long life even at high ambient temperatures.

The generator shaft operates with two encapsulated and permanently lubricated deep groove ball bearings made of stainless steel. In the front bearing, a special frictionless sealing disc prevents the ingress of moisture and dust. Grooving of the copper winding is done only by hand. Despite advanced automation on other components of generators, e.g. CNC manufacturing, hand crafting is prioritized here for good reason.

  It provides a complete inspection of processed insulation materials and thus meets IstaBreeze®'s quality standards. This series of generators is specially designed and optimally adapted for strong wind areas! Our product is made of aluminum, stainless and composite materials, so there is no rust problem and it can be used safely in all places.

This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.