Victron DC-DC Cyrix-Ct 12-24-120 Ampere Smart Battery Combiner CYR010120011

12/24V 120A Battery Combiner, CYR010120011, Victron
Model No: Cyrix-ct 12/24V-120A intelligent combiner

Intelligent battery monitoring to prevent unwanted transients

Some battery combiners (also called a voltage-controlled relay or split-charge relay) disconnect the battery in the event of a fault.

short but high amperage load. A battery splitter may also not be able to connect a large but discharged battery pack because

The DC voltage drops below the cut-out value immediately when batteries are connected.

The Cyrix-ct 12/24's software does more than simply connect and disconnect based on battery voltage.

fixed time delay. Cyrix-ct 12/24 looks at the general trend (voltage increase or decrease) and reverses the previous situation

take action only if the trend reverses within a certain period of time. Time delay depends on voltage deviation

from trend.

(For Battery Combiners with multiple arm/disarm profiles, please see Cyrix-i 400)

Long bolts allow connecting multiple power cables

Cyrix 12/24-120: 13mm (M6) Cyrix 12/24-230: 16mm (M8)

Protection against overheating (e.g. due to prolonged overload)

Cyrix will be disabled in case of excessive contact temperature and will be activated again after it has cooled down.

LED status indicator (Cyrix 12/24 230 only)

LED on: enabled LED flashing for 10 seconds: disabled

LED flashing for 2 sec: connecting LED flashing for 2 sec: disconnecting

LED flashing for 0.25 s: alarm (overtemperature; voltage > 16 V; both batteries < 10 V; one battery < 2 V)

(multiply by two for 24V)

12/24V auto range

Cyrix-ct 12/24 automatically detects system voltage.

No voltage loss

Cyrix battery combiners are an excellent alternative to diode isolators. Its main feature is that it is almost non-existent.

voltage loss, so there is no need to increase the output voltage of alternators or battery chargers.

Prioritizing the starter battery

In a typical installation, the alternator is connected directly to the starter battery. accessory battery and possibly a

The bow thruster and other batteries are each connected to the starter battery with Cyrix battery couplers. When Cyrix

detects when the starter battery has reached the connection voltage at which it will be activated to charge the other battery in parallel

batteries.

Bi-directional voltage detection and power supply from both batteries

Cyrix detects the voltage of both connected batteries. Therefore, it will also be activated when, for example, an accessory is used.

The battery is being charged by the battery charger.

Cyrix-ct has a 12/24 dual power supply. Therefore, it will also shut down if the voltage on a battery is too low to start.

Cyrix.

Cyrix-ct to prevent unexpected operation during installation or when a battery is disconnected

If the voltage at either battery connection is less than 2 V (12 V battery) or 4 V (24 V), the 12/24 will not turn off.

battery).

Parallel connection in case of emergency (Startup Assist)

Cyrix can also be armed with a push button (Cyrix remains armed for 30 seconds) or a switch to connect.

connect the batteries in parallel manually.

This is especially useful in emergency situations where the starter battery is discharged or damaged.

This product Sent by the seller Yapıbahçe.
The price of the product you have examined is determined by the seller.