IstaBreeze 1500 W 24 V Protected Wind Turbine + Hybrid Charge Controller
Set İ-1500 1500W 24V Windsafe Protected Wind Turbine + Hybrid Charge Controller iSTA-BREEZE
The newly developed IstaBreeze® WindSafe is a wind generator for long-term professional use, reliably providing energy automatically and unattended, even in difficult conditions.
The WindSafe IstaBreeze® wind turbine model features a revolutionary turbine protection system. The rotor is supported on a movable platform that elevates the entire structure by 90 degrees in strong wind, changing it according to the wind, reducing frontal oscillations and rotation. This protects the turbine from strong winds. This robust construction ensures the long life of our turbines and makes them a unique system in the category of mini wind generators.
The sizing of the generator components and the heat dissipation along the grooves in the aluminum housing of the generator ensure long-lasting use even at low ambient temperatures.
IstaBreeze®'s Wind/Solar Hybrid Charge Controller is an intelligent controller of wind turbine and solar cells that simultaneously controls you. The high-tech device can also be used as a monitoring system. It is used to charge and control your battery safely and efficiently with the combination of Wind Generator / Solar Module.
With its robust appearance, simple operation and integrated protection functions, this device features high efficiency and low load losses. This version of the controller will significantly increase the stability of all batteries and especially the life of the batteries.
Additionally, the control electronics in the control cabinet monitor the system voltage.
Features and product information are listed below:
Use of external and high quality (Triacs & Hyper Mosfet) solid state components. Increasing the lifespan of the controller.
Microprocessor controlled charging with integrated voltage and current limiting.
Electromagnetic brake control. Integrated 3-phase short-circuit switches (brake switch)
Protection against lightning strikes.
Protection against overcharge, deep discharge, short circuit, overload and false reverse polarity.
integrated display
The generator automatically brakes slowly when the battery is full, modern braking system with external load resistor (Dump Load) to prevent immediate blockage of the turbine, prolonging the life of the Stator.
THINGS TO BE CONSIDERED FOR CHARGER CONTROLLER CONNECTION!!!
one. Mount the charger close to the battery and in a place that is not hot.
2. Mount the load resistor horizontally, away from the battery and control device.
3. First connect the + terminals of the battery and the charger, then the – terminals, then connect the load resistor (resistance) connection to the load outputs and finally connect the 3 phase (ph) coming from the turbine to the inputs.
4. Check that the terminal connection screws are tightened well.
5. Check that the charge controller inverter and battery group are at the same voltage.
6. To stop the turbine manually, you can use a switch (63k automat or 3x25 on-off switch) between the wind turbine and the charge controller to reduce it to a three-phase short circuit when necessary.
7. Be sure to ground the body of the pole.
8. The length of the pole may be around 6-12 meters.
9. You can mount the pole tightly with ropes on 3 sides to prevent shaking in the wind.
10. Do not drill any part of the device while the charger is connected to the system. If you are going to drill for installation, the device must be in the off position.
This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.
Become a Seller/Service Provider
Solution Center
0850 309 51 23
.png){kind=logo}
The unit of all measurements is CM.
