Victron Energy MultiPlus Inverter Charger 1200VA - 12-1200-50-16

Uninterruptible AC power (UPS function)

In the event of a grid failure or shore or generator power outage, the inverter inside the Multi automatically kicks in and moves the supply to the connected loads. This process is done so quickly (less than 20 milliseconds) that your computers and other electronic equipment continue to operate without interruption.

Remote Monitoring and Control

Monitor and control your Quattro device and system or systems locally (LAN) or from anywhere in the world via the internet, using the free VRM app and VRM portal website. For multiple operating systems, access can be provided from a phone, tablet, laptop or computer. Via the required Color Control GX or Venus GX interface, there's no limit to the level of control, from tuning your Quattro device to setting a geofence for rental cars and more…

Proven reliability
The full bridge and toroidal transformer topology has proven its reliability over many years. The inverter is protected against short circuit, as well as overheating due to overload or high ambient temperature.

PowerControl - Dealing with limited generator, shoreside or grid power
Thanks to the Multi Control Panel, you can adjust the maximum generator or shore current. The MultiPlus uses all the extras available for charging, taking into account other AC loads and prevents the generator or shore supply from being overloaded.

PowerAssist – Increases the capacity of shore or generator power
Where peak power is often only required for a limited period of time, the MultiPlus ensures that insufficient shore or generator power is immediately compensated by power from the battery. When the load decreases, backup power is used to recharge the battery.

High starting power
LED is required to start high inrush loads such as lamps, halogen lamps or power converters of electric vehicles.

Look in
When Search Mode is "on", the power consumption of the inverter in no-load operation drops by approximately 70%. In this mode, when the Multi is operating in inverter mode, it is turned off at no load or at very low load and turned on briefly every two seconds. If the output current exceeds the set level, the inverter continues to operate. If it does not exceed, the inverter turns off again.

Programmable relay
By default, the programmable relay is set as alarm relay, meaning that in case of alarm or pre-alarm (inverter almost too hot, input ripple almost too high, battery voltage almost too low), the relay will be de-energized.