Istabreeze 60 cm Wing Set - White Ø1,25m

Istabreeze 60 cm Wing Set - White Ø1,25m

CHARGER CONTROLLER CONNECTION ISSUES TO BE CONSIDERED!!!

one.        Mount the charger close to the battery and in a place that is not hot.

2.        Mount the load resistor horizontally, away from the battery and control device.

3.        First connect the + terminals of the battery and the charger, then the – terminals, then connect the load resistor (resistance) connection to the load outputs and finally connect the 3 phase (ph) coming from the turbine to the inputs.

4.        Check that the terminal connection screws are tightened well.

5.        Check that the charge controller inverter and battery group are at the same voltage.

6.        To stop the turbine manually, place a switch between the wind turbine and the charge controller that will reduce it to a three-phase short circuit when necessary (63 k automat or 3x25 on-off switch).

7.        Be sure to ground the body of the pole.

8.        The length of the pole may be around 6-12 meters.

9.        You can mount the pole tightly with ropes on 3 sides to prevent shaking in the wind.

10.    Do not drill any part of the device while the charger is connected to the system. If you are going to drill for installation, the device must be in the off position.

60 cm Wing Set White Ø1.25m

Very quiet, robust replacement turbine blades for ISTA Breeze's wind generators.

Rotor blades made of composite material are very durable and robust but also unusually light for their low starting torque.

The wings operate silently thanks to their aerodynamic design and the materials used.

3x wings

1x aluminum flange

1x nose

This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.