Your Cart

IstaBreeze 107 cm Composite White Wing - 3 Pieces

FREE
SHIPPING
IstaBreeze 107 cm Composite White Wing - 3 Pieces
Brand Teknovasyon Arge
3.010,13 TL
Excluding Taxes: 2.508,44 TL
Contribute to reducing Co2 emissions by purchasing this product!

Estimated Delivery: Within 3 days

IstaBreeze 107 cm Composite White Wing - 3 Pieces

IstaBreeze Composite White Wing 107 cm 3 Pieces

Set containing 3 107 CM Reppeler blades for IstaBreeze wind generators.

Extremely quiet, robust standard replacement blades for small wind turbines. Rotor blades made of fiberglass are very durable and robust, but also unusually light for their low starting torque.

 

Length per repeater: 107cm

Weight: 650g

White color

Scope of delivery: 3 pieces

THINGS TO BE CONSIDERED FOR CHARGER CONTROLLER CONNECTION!!!

 

one.        Mount the charger close to the battery and in a place that is not hot.

2.        Mount the load resistor horizontally, away from the battery and control device.

3.        First connect the + terminals of the battery and the charger, then the – terminals, then connect the load resistor (resistance) connection to the load outputs and finally connect the 3 phase (ph) inputs coming from the turbine.

4.        Check that the terminal connection screws are tightened well.

5.        Check that the charge controller inverter and battery group are at the same voltage.

6.        To stop the turbine manually, place a switch between the wind turbine and the charge controller that will reduce it to a three-phase short circuit when necessary (63 k automat or 3x25 on-off switch).

7.        Be sure to ground the body of the pole.

8.        The length of the pole may be around 6-12 meters.

9.        You can mount the pole tightly with ropes on 3 sides to prevent shaking in the wind.

10.    Do not drill any part of the device while the charger is connected to the system. If you are going to drill for installation, the device must be in the off position.


This product Sent by the seller Teknovasyon Arge.
The price of the product you have examined is determined by the seller.

    

You can go to the My Orders section under your account and cancel your product if it has not been shipped yet.


If your product has been shipped, how to start the easy return process?


    1. Select the product to be returned and the reason for the return. If you have purchased more than one of the same product, you must also select the number of products to be returned.

    2. Contact us at support@azcarbon.com

    3. Take note of the cargo code that will be sent to you in line with the instructions and enter it in the field on your order screen.

    4. Do not forget to send the invoice with the products to be returned.



After the product reaches us, its compliance with the return conditions is checked.


Product If it meets the return conditions, your return will be approved, otherwise it will be sent back to your address.


The refund of your approved order depends on your bank. Your payment will be reflected on your card within 2-10 business days.


Refund for installment purchases will be made at once. It is made to your bank, but it is displayed in installments on the card statements.


After receiving the product, it must be installed by the authorized service. For your orders in the energy efficiency and mobility category of white goods such as refrigerators, washing machines, televisions, solar panels, inverters;


The package should not be opened without the knowledge of the authorized service; if it is opened, the product will be excluded from the scope of return.


If a problem is detected during the authorized service installation, you can only return the product with an authorized service report.